Cisco 300 Series

IP Addressing Commands
461 OL-32830-01 Command Line Interface Reference Guide
22
Parameters
• ip-address ip-address —Specifies the IP address.
• mac-address mac-address —Specifies the MAC address.
• interface-id —Specifies an interface ID.
Command Mode
Privileged EXEC mode
User Guidelines
Since the associated interface of a MAC address can be aged out from the FDB
table, the Interface field can be empty.
If an ARP entry is associated with an IP interface that is defined on a port or
port-channel, the VLAN field is empty.
Example
The following example displays entries in the ARP table.
22.12 show arp configuration
Use the show arp configuration privileged EXEC command to display the global
and interface configuration of the ARP protocol.
Syntax
show arp configuration
Parameters
This command has no arguments or key words.
switchxxxxxx# show arp
ARP timeout: 80000 Seconds
VLAN
-------
VLAN 1
VLAN 1
VLAN 2
Interface
---------------
gi1 1
gi1 2
gi1 1
gi1 2
IP Address
----------
10.7.1.102
10.7.1.135
11.7.1.135
12.10.1.13
HW Address
-----------------
00:10:B5:04:DB:4B
00:50:22:00:2A:A4
00:12:22:00:2A:A4
00:11:55:04:DB:4B
Status
-------
Dynamic
Static
Dynamic
Dynamic