Cisco 300 Series

Virtual Local Area Network (VLAN) Commands
OL-32830-01 Command Line Interface Reference Guide 1058
56
56.8 name
Use the name Interface Configuration (VLAN) mode command to name a VLAN.
Use the no form of this command to remove the VLAN name.
Syntax
name
string
no name
Parameters
• string —Specifies a unique name associated with this VLAN. (Length: 1–32
characters).
Default Configuration
No name is defined.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
The VLAN name must be unique.
Example
The following example assigns VLAN 19 the name Marketing.
switchxxxxxx(config)# interface vlan 19
switchxxxxxx(config-if)#
name Marketing
56.9 switchport protected-port
Use the switchport protected-port Interface Configuration mode command to
isolate Unicast, Multicast, and Broadcast traffic at Layer 2 from other protected
ports on the same switch. Use the no form of this command to disable protection
on the port.
Syntax
switchport protected-port