Cisco 300 Series User Manual

IPv6 First Hop Security
OL-32830-01 Command Line Interface Reference Guide 570
25
Command Mode
ND inspection Policy Configuration mode
User Guidelines
If this command is part of a policy attached to a VLAN, it is applied to all the ports
in the VLAN. If it is defined in a policy attached to a port in the VLAN, this value
overrides the value in the policy attached to the VLAN.
This command has no effect if dropping of unsecured messages is disabled.
Example
The following example defines an NDP Inspection policy named policy1, places
the switch in ND Inspection Policy Configuration mode, and specifies 2 as the
minimum CGA security level:
switchxxxxxx(config)# ipv6 nd inspection policy policy1
switchxxxxxx(config-nd-inspection)# sec-level minimum 2
switchxxxxxx(config-nd-inspection)# exit
25.64 show ipv6 dhcp guard
To display DHCPv6 Guard global configuration, use the show ipv6 dhcp guard
command in Privilege EXEC configuration mode.
Syntax
show ipv6 dhcp guard
Parameters
N/A
Command Mode
Privileged EXEC mode
User Guidelines
The show ipv6 dhcp guard command displays DHCPv6 Guard global
configuration.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48