Cisco 300 Series User Manual

SSH Client Commands
939 OL-32830-01 Command Line Interface Reference Guide
48
Example
The following example changes a password of the local SSH clients:
switchxxxxxx(config)# ip ssh-client change server password server 10.7.50.155
username john old-password &&&@@@aaff new-password &&&@@@aaee
48.3 ip ssh-client key
To create a key pair for SSH client authentication by public key (either by
generating a key or by importing a key), use the ip ssh-client key command in
Global Configuration mode. To remove a key, use the no form of the command.
Syntax
ip ssh-client key {dsa | rsa} {generate | key-pair
privkey pubkey }
encrypted ip ssh-client key {dsa | rsa} key-pair
encrypted-privkey pubkey
no ip ssh-client key [dsa | rsa]
Parameters
• dsa—DSA key type.
• rsa—RSA key type.
• key-pair—Key that is imported to the device.
- privkey —Plaintext private key.
- encrypted-privkey—private key is in encrypted format.
- pubkey —The plaintext pubic key.
Default Configuration
The application creates a key automatically; this is the default key.
Command Mode
Global Configuration mode

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48