Cisco 300 Series User Manual

Address Table Commands
145 OL-32830-01 Command Line Interface Reference Guide
5
You can execute the command before the VLAN is created.
Examples
Example 1 - The following example registers the MAC address to the bridge table:
switchxxxxxx(config)# interface vlan 8
switchxxxxxx(config-if)# bridge multicast address 01:00:5e:02:02:03
Example 2 - The following example registers the MAC address and adds ports
statically.
switchxxxxxx(config)# interface vlan 8
switchxxxxxx(config-if)# bridge multicast address 01:00:5e:02:02:03 add
gi11-2
5.4 bridge multicast forbidden address
To forbid adding or removing a specific Multicast address to or from specific ports,
use the bridge multicast forbidden address IInterface (VLAN) Configuration mode
command. To restore the default configuration, use the no form of this command.
Syntax
bridge multicast forbidden address {
mac-multicast-address |
ipv4-multicast-address
} {add | remove} {ethernet interface-list | port-channel
port-channel-list
}
no bridge multicast forbidden address {
mac-multicast-address }
Parameters
• mac-multicast-address | ipv4-multicast-address—Specifies the group
Multicast address.
• add—Forbids adding ports to the group.
• remove—Forbids removing ports from the group.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48