Cisco 300 Series User Manual

IPv6 Commands
OL-32830-01 Command Line Interface Reference Guide 628
27
vlan 100 up/up enabled FE80::0DB8:12AB:FA01 1 1
vlan 1000 up/up stalled FE80::0DB8:12AB:FA01 1 1
27.14 show ipv6 link-local default zone
Use the show ipv6 link-local default zone command in user EXEC or privileged
EXEC mode to display the IPv6 link local default zone.
Syntax
show ipv6 link-local default zone
Command Mode
User EXEC mode
Privileged EXEC mode
Examples
Example 1. The following example displays the default zone when it is defined:
switchxxxxxx# show ipv6 link-local default zone
Link Local Default Zone is VLAN 1
Example 2. The following example displays the default zone when it is not defined:
switchxxxxxx# show ipv6 link-local default zone
Link Local Default Zone is not defined
27.15 show ipv6 neighbors
Use the show ipv6 neighbors command in User EXEC or Privileged EXEC mode to
display IPv6 neighbor discovery (ND) cache information.
Syntax
show ipv6 neighbors [
interface-id | ipv6-address | ipv6-hostname ]

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48