Cisco 300 Series User Manual

SYSLOG Commands
963 OL-32830-01 Command Line Interface Reference Guide
49
Example
The following example configures the VLAN 10 as the source interface.
switchxxxxxx(config)# logging source-interface vlan 100
49.11 logging source-interface-ipv6
To specify the source interface whose IPv6 address will be used as the source
IPv6 address for communication with IPv6 SYSLOG servers, use the logging
source-interface-ipv6 Global Configuration mode command. To restore the default
configuration, use the no form of this command.
Syntax
logging source-interface-ipv6
interface-id
no logging source-interface-ipv6
Parameters
interface-id —Specifies the source interface.
Default Configuration
The IPv6 source address is the defined IPv6 address of the outgoing interface and
selected in accordance with RFC6724.
Command Mode
Global Configuration mode
User Guidelines
If the source interface is the outgoing interface, the IPv6 address defined on the
interfaces and selected in accordance with RFC 6724.
If the source interface is not the outgoing interface, the minimal IPv6 address
defined on the source interface with the scope of the destination IPv6 address is
applied.
If there is no available IPv6 source address, a SYSLOG message is issued when
attempting to communicate with an IPv6 SYSLOG server.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48