Cisco 300 Series User Manual

Address Table Commands
OL-32830-01 Command Line Interface Reference Guide 144
5
5.3 bridge multicast address
To register a MAC-layer Multicast address in the bridge table and statically add or
remove ports to or from the group, use the bridge multicast address Interface
(VLAN) Configuration mode command. To unregister the MAC address, use the no
form of this command.
Syntax
bridge multicast address {
mac-multicast-address | ipv4-multicast-address} [[add |
remove] {ethernet interface-list
| port-channel port-channel-list }]
no bridge multicast address { mac-multicast-address }
Parameters
• mac-multicast-address | ipv4-multicast-address—Specifies the group
Multicast address.
• add—(Optional) Adds ports to the group.
• remove—(Optional) Removes ports from the group.
• ethernet interface-list—(Optional) Specifies a list of Ethernet ports.
Separate nonconsecutive Ethernet ports with a comma and no spaces. Use
a hyphen to designate a range of ports.
• port-channel port-channel-list—(Optional) Specifies a list of port channels.
Separate nonconsecutive port-channels with a comma and no spaces; use
a hyphen to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
If ethernet interface-list or port-channel port-channel-list is specified without
specifying add or remove, the default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
To register the group in the bridge database without adding or removing ports or
port channels, specify the mac-multicast-address parameter only.
Static Multicast addresses can be defined on static VLANs only.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48