Line Commands
OL-32830-01 Command Line Interface Reference Guide 642
29
Command Mode
Line Configuration Mode
User Guidelines
The configured speed is only applied when autobaud is disabled. This
configuration applies to the current session only.
Example
The following example configures the line baud rate as 9600 bits per second.
switchxxxxxx(config-line)#
speed 9600
29.5 show line
To display line parameters, use the show line Privileged EXEC mode command.
Syntax
show line
[
console
| telnet | ssh]
Parameters
• console—(Optional) Displays the console configuration.
• telnet—(Optional) Displays the Telnet configuration.
• ssh—(Optional) Displays the SSH configuration.
Default Configuration
If the line is not specified, all line configuration parameters are displayed.
Command Mode
Privileged EXEC mode
Example
The following example displays the line configuration.
switchxxxxxx#
show line
To Next Page
Loading...
