Cisco 300 Series User Manual

DHCP Server Commands
299 OL-32830-01 Command Line Interface Reference Guide
12
12.21 show ip dhcp binding
To display the specific address binding or all the address bindings on the DHCP
server, use the show ip dhcp binding command in User EXEC mode.
Syntax
show ip dhcp binding
[ ip-address ]
Parameters
• ip-address —(Optional) Specifies the IP address.
Command Mode
User EXEC mode
Examples
The following examples display the DHCP server binding address parameters.
switchxxxxxx# show ip dhcp binding
DHCP server enabled
The number of used (all types) entries is 6
The number of pre-allocated entries is 1
The number of allocated entries is 1
The number of expired entries is 1
The number of declined entries is 2
The number of static entries is 1
The number of dynamic entries is 2
The number of automatic entries is 1
IP address Hardware Address Lease Expiration Type State
Lease
expiration
The lease expiration date of the host IP address.
Type The manner in which the IP address was assigned
to the host.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48