Cisco 300 Series User Manual

SYSLOG Commands
OL-32830-01 Command Line Interface Reference Guide 964
49
Example
The following example configures the VLAN 10 as the source interface.
switchxxxxxx(config)# logging source-interface-ipv6 vlan 100
49.12 logging aggregation on
To control aggregation of SYSLOG messages, use the logging aggregation on
Global Configuration mode command. If aggregation is enabled, logging
messages are displayed every time interval (according to the aging time specified
by logging aggregation aging-time). To disable aggregation of SYSLOG
messages, use the no form of this command.
Syntax
logging aggregation on
no logging aggregation on
Parameters
This command has no arguments or keywords.
Default Configuration
Enabled.
Command Mode
Global Configuration mode
Example
To turn off aggregation of SYSLOG messages:
switchxxxxxx(config)# no logging aggregation on

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48