802.1X Commands
75 OL-32830-01 Command Line Interface Reference Guide
2
User Guidelines
Any combination of the keywords are allowed. At least one keyword must be
configured.
A rate limit is applied to the traps: not more than one trap of this type can be sent in 10
seconds.
Example
The following example enables
sending traps when a MAC address is successfully
authorized by the 802.1X MAC-authentication access control
.
switchxxxxxx(config)#
dot1x traps authentication success mac
2.29 dot1x unlock client
Use the dot1x unlock client Privileged EXEC mode command to unlock a locked (in
the quiet period) client.
Syntax
dot1x unlock client
interface-id mac-address
Parameters
•
interface-id
—Interface ID where the client is connected to.
•
mac-address
—Client MAC address.
Default Configuration
The client is locked until the silence interval is over.
Command Mode
Privileged EXEC mode
User Guidelines
Use this command to unlock a client that was locked after the maximum allowed
authentication failed attempts and to end the quiet period. If the client is not in the
quiet period, the command has no affect.
To Next Page
Loading...
