Cisco 300 Series User Manual

Smartport Commands
843 OL-32830-01 Command Line Interface Reference Guide
44
Default Configuration
Enabled
Command Mode
Global Configuration mode
Example
To enable CDP globally:
switchxxxxxx(config)# macro auto processing cdp
44.8 macro auto processing lldp
The macro auto processing lldp Global Configuration mode command enables
using the LLDP capability information to identify the type of an attached device.
When Auto Smartport is enabled on an interface and this command is run, the
switch automatically applies the corresponding Smartport type to the interface
based on the LLDP capabilities advertised by the attaching device(s).
The no format of the command disables the feature.
Syntax
macro auto processing lldp
no macro auto processing lldp
Parameters
This command has no arguments or keywords.
Default Configuration
Enabled
Command Mode
Global Configuration mode

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48