Cisco 300 Series User Manual

Configuration and Image File Commands
OL-32830-01 Command Line Interface Reference Guide 264
10
Syntax
boot system {image-1 | image-2}
Parameters
• image-1—Specifies that image-1 is loaded as the system image during the
next device startup.
• image-2—Specifies that image-2 is loaded as the system image during the
next device startup.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
Use the show bootvar command to display the active image.
Example
The following example specifies that image-1 is the active system image file
loaded by the device at startup. The results of this command is displayed in show
bootvar.
switchxxxxxx# boot system image-1
10.8 show running-config
Use the show running-config privileged EXEC command to display the contents of
the currently running configuration file.
show running-config [interface i
nterface-id-list | detailed | brief]
Parameters
• interface interface-id-list —Specifies a list of interface IDs. The interface IDs
can be one of the following types: Ethernet port, port-channel or VLAN.
• detailed—Displays configuration with SSL and SSH keys.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48