Cisco 300 Series

Address Table Commands
157 OL-32830-01 Command Line Interface Reference Guide
5
Syntax
bridge multicast ipv6 source
ipv6-source-address group ipv6-multicast-address
[[add | remove] {ethernet interface-list | port-channel port-channel-list}]
no bridge multicast ipv6 source ipv6-address group ipv6-multicast-address
Parameters
• ipv6-source-address—Specifies the source IPv6 address.
• ipv6-multicast-address—Specifies the group IPv6 Multicast address.
• add—(Optional) Adds ports to the group for the specific source IPv6
address.
• remove—(Optional) Removes ports from the group for the specific source
IPv6 address.
• ethernet interface-list —(Optional) Specifies a list of Ethernet ports.
Separate nonconsecutive Ethernet ports with a comma and no spaces. Use
a hyphen to designate a range of ports.
• port-channel port-channel-list —(Optional) Specifies a list of port channels.
Separate nonconsecutive port-channels with a comma and no spaces. Use
a hyphen to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
The default option is add.
Command Mode
Interface (VLAN) Configuration mode
Example
The following example registers a source IPv6 address - Multicast IPv6 address
pair to the bridge table:
switchxxxxxx(config)# interface vlan 8
switchxxxxxx(config-if)# bridge multicast source 2001:0:0:0:4:4:4 group
FF00:0:0:0:4:4:4:1