Link Layer Discovery Protocol (LLDP) Commands
671 OL-32830-01 Command Line Interface Reference Guide
30
Syntax
show lldp med configuration
[interface-id | detailed
]
Parameters
• interface-id—(Optional) Specifies the port ID.
• detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Default Configuration
If no port ID is entered, the command displays information for all ports. If detailed is
not used, only present ports are displayed.
Command Mode
Privileged EXEC mode
Examples
Example 1 - The following example displays the LLDP MED configuration for all
interfaces.
switchxxxxxx#
show lldp med configuration
Fast Start Repeat Count: 4.
lldp med network-policy voice: manual
Network policy 1
-------------------
Application type: voiceSignaling
VLAN ID: 1 untagged
Layer 2 priority: 0
DSCP: 0
Port Capabilities Network Policy Location Notifications Inventory
------ -------------- -------------- ---------- ------------- --------
gi11 Yes Yes Yes Enabled Yes
gi12 Yes Yes No Enabled No
To Next Page
Loading...
