Cisco 300 Series

Virtual Local Area Network (VLAN) Commands
OL-32830-01 Command Line Interface Reference Guide 1078
56
Port Mode: Trunk
Ingress UnTagged VLAN(NATIVE): 2
Gvrp Status: disabled4
Protected: Enabled, Uplink is gi14.
802.1x state: single-host mode, authorized, PVID is changed to Radius assigned
VLAN_ID
Port gi1 1 is member in:
VLAN Name Egress Rule Type
---- ---------- ----------- -----
1 default untagged Default
8 8 tagged Dynamic
11 11 tagged Static
19 IPv6VLAN untagged Static
72 72 untagged Static
120 untagged RADIUS Assigned VLAN
Forbidden VLANS:
VLAN Name
---- ---------
73 Out
Classification rules:
Mac-based VLANs:
Group ID Vlan ID
Example 2—The following example displays the command output for an access
port:
switchxxxxxx# show interfaces switchport gi1 2
Port
gi1 2:
Port Mode: Access
Ingress UnTagged VLAN (NATIVE): 1
Gvrp Status: disabled
Protected: Disabled