Cisco 300 Series User Manual

Address Table Commands
147 OL-32830-01 Command Line Interface Reference Guide
5
Syntax
bridge multicast ip-address
ip-multicast-address [[add | remove] {interface-list |
port-channel port-channel-list }]
no bridge multicast ip-address
ip-multicast-address
Parameters
• ip-multicast-address—Specifies the group IP Multicast address.
• add—(Optional) Adds ports to the group.
• remove—(Optional) Removes ports from the group.
• interface-list —(Optional) Specifies a list of Ethernet ports. Separate
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
• port-channel port-channel-list —(Optional) Specifies a list of port channels.
Separate nonconsecutive port-channels with a comma and no spaces. Use
a hyphen to designate a range of port channels.
Default Configuration
No Multicast addresses are defined.
Default option is add.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
To register the group in the bridge database without adding or removing ports or
port channels, specify the ip-multicast-address parameter only.
Static Multicast addresses can be defined on static VLANs only.
You can execute the command before the VLAN is created.
Example
The following example registers the specified IP address to the bridge table:
switchxxxxxx(config)# interface vlan 8

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48