Cisco 300 Series

Address Table Commands
OL-32830-01 Command Line Interface Reference Guide 180
5
show bridge multicast address-table static [vlan vlan-id] [address
ipv4-multicast-address] [source ipv4-source-address]
show bridge multicast address-table static [vlan vlan-id] [address
ipv6-multicast-address] [source ipv6-source-address]
Parameters
• vlan vlan-id —(Optional) Specifies the VLAN ID.
• address—(Optional) Specifies the Multicast address. The possible values
are:
- mac-multicast-address—(Optional) Specifies the MAC Multicast
address.
- ipv4-multicast-address—(Optional) Specifies the IPv4 Multicast
address.
- ipv6-multicast-address—(Optional) Specifies the IPv6 Multicast
address.
• source—(Optional) Specifies the source address. The possible values are:
- ipv4-address—(Optional) Specifies the source IPv4 address.
- ipv6-address—(Optional) Specifies the source IPv6 address.
Default Configuration
When all/mac/ip is not specified, all entries (MAC and IP) will be displayed.
Command Mode
Privileged EXEC mode
User Guidelines
A MAC address can be displayed in IP format only if it is within the range
0100.5e00.0000–- 0100.5e7f.ffff.