Cisco 300 Series User Manual

DNS Client Commands
359 OL-32830-01 Command Line Interface Reference Guide
15
no ip host name ip host name [ address1...address8 ]
Parameters
• hostname —Name of the host. (Length: 1–158 characters. Maximum label
length of each domain level is 63 characters).
• address1 —Associated host IP address (IPv4 or IPv6, if IPv6 stack is
supported).
• address2 ... address8 —Up to seven additional associated IP addresses,
delimited by a single space (IPv4 or IPv6, if IPv6 stack is supported).
Default Configuration
No host is defined.
Command Mode
Global Configuration mode
User Guidelines
Host names are restricted to the ASCII letters A through Z (case-insensitive), the
digits 0 through 9, the underscore and the hyphen. A period (.) is used to separate
labels.
An IP application will receive the IP addresses in the following order:
1. IPv6 addresses in the order specified by the command.
2. IPv4 addresses in the order specified by the command.
Use the no format of the command with the
address1...address8 argument to
delete the specified addresses. The entry is deleted if all its addresses are
deleted.
Example
The following example defines a static host name-to-address mapping in the host
cache.
switchxxxxxx(config)# ip host accounting.website.com 176.10.23.1

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48