Cisco 300 Series User Manual

IPv6 First Hop Security
OL-32830-01 Command Line Interface Reference Guide 504
25
• match server address
• match reply
• preference
Each policy of the same type (for example, DHCPv6 Guard policies) must have a
unique name. Policies of different types can have the same policy name.
The switch supports two predefined, default DHCPv6 Guard policies named:
"vlan_default" and "port_default":
ipv6 dhcp guard policy vlan_default
exit
ipv6 dhcp guard policy port_default
exit
The default policies are empty and cannot be removed, but can be changed. The
no ipv6 dhcp guard policy does not remove the default policies, it only removes
the policy configuration defined by the user.
The default policies cannot be attached by the ipv6 dhcp guard attach-policy
(port mode) or ipv6 dhcp guard attach-policy (VLAN mode) command. The
vlan_default policy is attached by default to a VLAN, if no other policy is attached
to the VLAN. The port_default policy is attached by default to a port, if no other
policy is attached to the port.
You can define a policy using the ipv6 dhcp guard policy command multiple times.
Before an attached policy is removed, a request for confirmation is presented to
the user, as shown in Example 3 below.
Examples
Example 1—The following example defines a DHCPv6 Guard policy named
policy1, places the router in DHCPv6 Guard Policy Configuration mode, configures
the port to drop unsecure messages and sets the device role as router:
switchxxxxxx(config)# ipv6 dhcp guard policy policy1
switchxxxxxx(config-dhcp-guard)# match server address list1
switchxxxxxx(config-dhcp-guard)# device-role server
switchxxxxxx(config-dhcp-guard)# exit

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48