Cisco 300 Series User Manual

IPv6 First Hop Security
521 OL-32830-01 Command Line Interface Reference Guide
25
ipv6 nd inspection policy port_default
exit
These policies cannot be removed, but they can be changed. The no ipv6 nd
inspection policy does not remove these policies, it only removes the policy
configuration defined by the user.
The default policies cannot be attached by the ipv6 nd inspection attach-policy
(port mode) or ipv6 nd inspection attach-policy (VLAN mode) command. The
vlan_default policy is attached by default to a VLAN, if no other policy is attached
to the VLAN. The port_default policy is attached by default to a port, if no other
policy is attached to the port.
You can define a policy using the ipv6 nd inspection policy command multiple
times.
If an attached policy is removed it is detached automatically before removing.
Examples
Example 1. The following example defines a ND Inspection policy named policy1,
places the switch in ND Inspection Policy Configuration mode, and configures the
port to drop unsecured messages and sets the device role as router:
switchxxxxxx(config)# ipv6 nd inspection policy policy1
switchxxxxxx(config-nd-inspection)# drop-unsecure
switchxxxxxx(config-nd-inspection)# device-role router
switchxxxxxx(config-nd-inspection)# exit
Example 2. The following example defines an ND Inspection policy as policy1 by a
few steps:
switchxxxxxx(config)# ipv6 nd inspection policy policy1
switchxxxxxx(config-nd-inspection)# drop-unsecure
switchxxxxxx(config-nd-inspection)# exit
switchxxxxxx(config)# ipv6 nd inspection policy policy1
switchxxxxxx(config-nd-inspection)# device-role router

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48