Cisco 300 Series User Manual

IPv6 Commands
OL-32830-01 Command Line Interface Reference Guide 622
27
User Guidelines
Use this command to validate the IPv6 status of an interface and its configured
addresses. This command also displays the parameters that IPv6 uses for
operation on this interface and any configured features.
If the interface’s hardware is usable, the interface is marked up.
If you specify an optional interface identifier, the command displays information
only about that specific interface. For a specific interface, you can enter the prefix
keyword to see the IPv6 neighbor discovery (ND) prefixes that are configured on
the interface.
Examples
Example 1. The show ipv6 interface command displays information about the
specified interface:
switchxxxxxx# show ipv6 interface vlan 1
VLAN 1 is up/up
IPv6 is enabled, link-local address is FE80::0DB8:12AB:FA01
Global unicast address(es):
Ipv6 Global Address Type
2000:0DB8::2/64 (ANY) Manual
2000:0DB8::2/64 Manual
2000:1DB8::2011/64 Manual
Joined group address(es):
FF02::1
FF02::2
FF02::1:FF11:6770
MTU is 1500 bytes
ICMP error messages limited interval is 100ms; Bucket size is 10 tokens
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
Stateless autoconfiguration is enabled.
MLD Version is 2
Field Descriptions:

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48