Cisco 300 Series User Manual

Link Layer Discovery Protocol (LLDP) Commands
679 OL-32830-01 Command Line Interface Reference Guide
30
gi14 0 0 0 0 0 0 0
The following table describes significant LLDP fields shown in the display:
Field Description
Port The port number.
Device ID The neighbor device’s configured ID (name) or MAC
address.
Port ID The neighbor device’s port ID.
System name The neighbor device’s administratively assigned
name.
Capabilities The capabilities discovered on the neighbor device.
Possible values are:
B - Bridge
R - Router
W - WLAN Access Point
T - Telephone
D - DOCSIS cable device
H - Host
r - Repeater
O - Other
System description The neighbor device’s system description.
Port description The neighbor device’s port description.
Management
address
The neighbor device’s management address.
Auto-negotiation
support
The auto-negotiation support status on the port.
(Supported or Not Supported)
Auto-negotiation
status
The active status of auto-negotiation on the port.
(Enabled or Disabled)
Auto-negotiation
Advertised
Capabilities
The port speed/duplex/flow-control capabilities
advertised by the auto-negotiation.
Operational MAU
type
The port MAU type.
LLDP MED
Capabilities The sender's LLDP-MED capabilities.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48