MLD Snooping Commands
715 OL-32830-01 Command Line Interface Reference Guide
34
Syntax
show ipv6 mld snooping groups [vlan
vlan-id
] [address
ipv6-multicast-address
]
[source
ipv6-address
]
Parameters
• vlan
vlan-id
—(Optional) Specifies the VLAN ID.
• address
ipv6-multicast-address
—(Optional) Specifies the IPv6 multicast
address.
• source
ipv6-address
—(Optional) Specifies the IPv6 source address.
Command Mode
User EXEC mode
Default Configuration
Display information for all VLANs and addresses defined on them.
User Guidelines
To see the full multicast address table (including static addresses), use the show
bridge multicast address-table command.
The Include list contains the ports which are in a forwarding state for this group
according to the snooping database. In general, the Exclude list contains the ports
which have issued an explicit Exclude for that specific source in a multicast group.
The Reporters That Are Forbidden Statically list contains the list of ports which
have asked to receive a multicast flow but were defined as forbidden for that
multicast group in a multicast bridge.
Note: Under certain circumstances, the Exclude list may not contain accurate
information; for example, in the case when two Exclude reports were received on
the same port for the same group but for different sources, the port will not be in
the Exclude list but rather in the Include list
To Next Page
Loading...
Need help?
General
