Cisco 300 Series

Router Resources Commands
OL-32830-01 Command Line Interface Reference Guide 814
42
Data Validation:
If the new settings exceed the maximum number of routing entries, the command
is rejected and a message is displayed to the user.
If the new settings are fewer than the currently in-use routing entries, a
confirmation message is displayed to the user (before the save confirmation
message).
Use the no system router resources command to restore the default settings.
The following table displays the conversion between logical entities to HW
entries:
Examples
Example 1
The following example defines the supported number of IPv4 routing entries.
switchxxxxxx(config)# system router resources ip-routes 256
The maximal number of IPv4 Routing Entries plus Non-IP Entries is 2048.
In-Use Reserved (Current) Reserved (New)
------ ------------------ --------------
IPv4 Entries 232 1024 256
Number of Routes 20
Number of Neighbors 12
Number of Interfaces 100
Non-IP Entries:
- Unit 1 93% 400
- Unit 2 94% 400
- Unit 5 90% 400
Logical Entity
IPv4
IPNeighbor 1entry
IPAddress 2entries
IPRemoteRoute 1entry