Cisco 300 Series User Manual

Network Management Protocol (SNMP) Commands
OL-32830-01 Command Line Interface Reference Guide 870
45
encrypted snmp-server user username groupname {v1 | v2c | [ remote host] v3[ auth
{md5 | sha} encrypted-auth-password [priv encrypted-priv-password]]}
no snmp-server user username {v1 | v2c | [remote host] v3[ auth {md5 | sha}
Parameters
• username—Define the name of the user on the host that connects to the
agent. (Range: Up to 20 characters).
• groupname—The name of the group to which the user belongs. The group
should be configured using the command snmp-server group with v1 or v2c
parameters (no specific order of the 2 command configurations is imposed
on the user). (Range: Up to 30 characters)
• v1—Specifies that the user is a v1 user.
• v2c—Specifies that the user is a v2c user..
• v3—Specifies that the user is a v3 user..
• remote host —(Optional) IP address (IPv4, IPv6 or IPv6z) or host name of the
remote SNMP host. See IPv6z Address Conventions.
• auth—(Optional) Specifies which authentication level is to be used.
• md5—(Optional) Specifies the HMAC-MD5-96 authentication level.
• Sha—(Optional) Specifies the HMAC-SHA-96 authentication level.
• auth-password—(Optional) Specifies the authentication password. Range:
Up to 32 characters.
• encrypted-auth-password—(Optional) Specifies the authentication
password in encrypted format.
• priv-password—(Optional) Specifies the privacy password (The
encryption algorithm used is data encryption standard - DES). Range: Up to
64 characters.
• encrypted-priv-password—(Optional) Specifies the privacy password in
encrypted format.
Default Configuration
No group entry exists.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48