Cisco 300 Series User Manual

Network Management Protocol (SNMP) Commands
877 OL-32830-01 Command Line Interface Reference Guide
45
• udp-port port —(Optional) UDP port of the host to use. The default is 162.
(Range: 1–65535)
• filter filtername —(Optional) Filter for this host. If unspecified, nothing is
filtered. The filter is defined using snmp-server filter (no specific order of
commands is imposed on the user). (Range: Up to 30 characters)
• timeout seconds —(Optional) (For informs only) Number of seconds to wait
for an acknowledgment before resending informs. The default is 15
seconds. (Range: 1–300)
• retries retries —(Optional) (For informs only) Maximum number of times to
resend an inform request, when a response is not received for a generated
message. The default is 3. (Range: 0–255)
Default Configuration
Version: SNMP V1
Type of notification: Traps
udp-port: 162
If informs are specified, the default for retries: 3
Timeout: 15
Command Mode
Global Configuration mode
User Guidelines
The logical key of the command is the list (ip-address/hostname, traps/informs,
version).
When configuring SNMP v1 or v2 notifications recipient, the software
automatically generates a notification view for that recipient for all MIBs.
For SNMPv3 the software does not automatically create a user or a notify view.
, use the commands snmp-server user (ISCLI) and snmp-server group to create a
user or a group.
Example
The following defines a host at the IP address displayed.

Cisco 300 Series Specifications

General

Model	Cisco 300 Series
Category	Switch
Dimensions	Varies by model
Weight	Varies by model
Power over Ethernet (PoE)	Available on select models
Management	Web-based GUI, SNMP, CLI
VLANs	Up to 256
Security Features	ACLs, 802.1X, Port Security
Humidity	10% to 90% non-condensing
Ports	8, 16, 24, 48