iPECS UCP - 2.32 Alternative Route Selection(ARS) for Digit conversion table

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
94
Table 3.3.5.9-1 ISDN CO LINE ATTRIBUTES (PGM 151)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
8
01-02 T305 (10 – 60)
(10-60) : 30 (sec)
T305 establishes the Interval for a
Released signal after receiving a
Disconnect message.
10~60
(seconds)
30
9
01-02 T308 (01 – 10)
(01-10) : 04 (sec)
T308 establishes the Interval for a
Released ACK signal after sending
a release message.
1~10
(seconds)
4
10
01-02 T309 (001 – 100)
(001-100) : 090 (sec)
Optional state timer. 1~100
(seconds)
90
11
01-02 T310 (10 – 60)
(10-60) : 40 (sec)
Timer used in accepting Received
signal.
10~60
(seconds)
40
12
01-02 N200 (1 – 5)
(1-5) : 3
The terminal shall provide one
N200 counter for each logical link
supported. The default value of this
counter shall be 3.
1~5 3
13
01-02 N201 (250 – 300 )
(250~300) : 260 (byte)
The N201 counter sets the
maximum number of Octets in the
ISDN information field.
250~300
(bytes)
260
14
01-02 N202 (1 – 5)
(1-5) :3
If the terminal transmits a TEI
Identify Request message (to
request assignment of a TEI), the
terminal shall provide one N202
counter for each logical link that it
supports.
1~5 3
15
01-02 N204 ( 1 – 5)
(1-5) : 1
The N204 counter establishes the
maximum number of XID re-
transmissions from the terminal.
1~5 1
16
01-02 K_VALUE
(1-5) : 1
The terminal shall provide one K
counter for each logical link
supported.
1~5 1