iPECS UCP - Emg ‘Speed Numbering’; In Case of UCP

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
243
In case of UCP
You can set VOIU in this page. The MCIU (Audio Conference) channel is flexible according to
VoIU ‘Enable or Disable’ and installing the related module as below:
eMG ‘Speed Numbering’
You can easily memory the system speed dial code and station dial code by selecting the desired
type depending on the situation among the following types:
1) Type (0): System speed (2000~4999), Station speed (000~099)
eMG80
2) Type (1): System speed (200~999), Station speed (000~099)
3) Type (2): System speed (200~999), Station speed (00~19)
4) Type (3): System speed (20~99), Station speed (00~19)
5) Type (4): System speed (1000~3999), Station speed (000~099)
6) Type (5): System speed (100~999), Station speed (000~099)
7) Type (6): System speed (100~999), Station speed (00~09)
8) Type (7): System speed (10~99), Station speed (00~09)
9) Type (8): System speed (1~9), Station speed (0~0)
eMG800
1) Type (0): System speed (2000~9999), Station speed (000~099)
2) Type (1): System speed (200~999), Station speed (000~099)
3) Type (2): System speed (200~999), Station speed (00~19)
4) Type (3): System speed (20~99), Station speed (00~19)
5) Type (4): System speed (1000~8999), Station speed (000~099)
6) Type (5): System speed (100~999), Station speed (000~099)
7) Type (6): System speed (100~999), Station speed (00~09)
8) Type (7): System speed (10~99), Station speed (00~09)
9) Type (8): System speed (1~9), Station speed (0~0)