iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
58
3.3.3.6 CO/IP Group Access – PGM 117
Stations can be allowed or denied access to CO Lines and IP Channels by group (eMG80: 20
/eMG800:200), refer to CO Line Attributes, PGM 141, button 1. As a default, all stations are
allowed access to all groups except Private Lines (group 00) and unused CO Lines. The CO Line
of an RSGM is assigned as a Private Line by default.
PROCEDURE:
CO/IP GROUP ACCESS
ENTER STA RANGE
1. Press the [PGM] button and dial 117.
100 – 110 CO/IP GRP
PRESS FLEX KEY (01-20)
Use the dial-pad to enter a station range (Ex. 100~110). For
a single station, enter the same number twice.
The first 20 Flex button LEDs indicate group access for
eMG.
Press the desired Flex button to toggle CO/IP Group
access,
LED on: group access allowed
LED off: group access not allowed
Press the [Save] button to store the data entry.
3.3.3.7 Internal Page Zone Access – PGM 118
Each iPECS IP and LDP Phone is assigned to receive announcements from each Internal Page
Zone. A station can be assigned to any, all or no zones. Note a remote station or a station not
assigned to any Internal Zone will not receive any page announcements including Internal All Call.
As a default, all stations except remote stations are assigned to zone 1.
PROCEDURE:
INTERNAL PAGE ZONE
ENTER STA NUMBER
1. Press the [PGM] button and dial 118.
100-110 I-PAGE ZONE
PRESS FLEX KEY (001-024)
Use the dial-pad to enter a station range (Ex. 100~110). For
a single station, enter the same number twice.
The LEDs indicate the status for Page Zones 1 to 24, Use
the [VOL UP]/[VOL DOWN] button to display Page Zones
25 to 35.
Press the desired Flex button to toggle Internal Page
Zone assignments,
LED On: station receives announcement
LED Off: station does not receive announcement.
Press the [Save] button to store the Page Zone data.
To Next Page
Loading...
