iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
591
2) After re fresh, the following figure is displayed and click the apply button to activate.
3) The final step is to reset the gateway license and then refresh. You can see the following
figure for Gateway license.
4.5.7.3 Temp License Activation
Before Temp License Activation, make sure that the date of system is set correctly. In this page,
Temp License can be activated by clicking [Activation] button. Remaining days and activation
times are displayed in State column. The Temp License can be activated totally 6 times. It is valid
for 60 days at first activation and is valid 30 days from second activation. Therefore the license
file which has correct port number and features must be uploaded. Otherwise, system may enter
“Limited Service Mode” due to the mismatched license.
Figure 4.5.7.3-1 Temp License Activation
Notification
1) Please back up your DB before you activate a temporary license.
2) Must verify the present license before the temporary license expires.
3) If a temp license expires, upload a new license file or use within the scope of current
license file. Otherwise, the system may go to [Limited Service Mode].
To Next Page
Loading...
