iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
433
4.4.7.2 CLIP/COLP Table - PGM 201
Selecting CLIP/COLP Table will display the CLIP/COLP Table Attributes data entry page. Click
[Save] button after changing Value.
Figure 4.4.7.2-1 CLIP/COLP Table
Normally, the system will send the primary Directory Number of the ISDN Line in the ISDN call
SETUP and CONNECT messages to identify the caller (CLIP) or the answering (COLP) party
respectively. Under certain circumstances, it may be desirable to provide the secondary or DID
number for the ISDN Line. In these cases, the CLIP/COLP Table may be used to define the digits
sent. The number sent is selected based on the index assigned for the CO/IP Line under
‘CID/CPN Attributes section’.
The CLI Station Number is sent in place of the station number. For all other entries, the station
number is sent as a suffix to the number in the Table. Note that this number is sent only if
CLIR/COLR is disabled under the CLIR Service and COLR Service assignments in the Station
ISDN Attributes.
You can set the CID password to click “Go to Setting” button. After clicking it, you will move to the
following PGM 162 and set the CID password, and then save CID password to mark tick on the
save box and click the Save button.
Setting CID Password directly
To Next Page
Loading...
