iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
283
4.4.2.7 CO/IP Group Access - PGM 117
Selecting CO/IP Group Access will display the CO/IP Group Access data input page. Enter a
valid station range and click [Load] to enter CO/IP Group Access data. Check the appropriate
boxes to allow or delete access to each CO/IP Group. Click [Save] button after changing Value to
apply.
Figure 4.4.2.7-1 CO/IP Group Access
Stations can be allowed or denied access to CO Lines and IP Channels by group (eMG80: 20 &
eMG800/UCP: 200). As a default, all stations are allowed access to all groups except Private
Lines (group 00) and unused CO Lines. The CO Line is assigned as a Private Line by default.
To Next Page
Loading...
