iPECS UCP - 2.81 System Scenario Call Routing

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
244
UCP ‘Speed Numbering’
You can easily memory the system speed dial code and station dial code by selecting the desired
type depending on the situation among the following types:
1) Type (0): System speed (20000~31999), Station speed (000~099)
2) Type (1): System speed (2000~9999), Station speed (000~099)
3) Type (2): System speed (200~999), Station speed (000~099)
4) Type (3): System speed (200~999), Station speed (00~19)
5) Type (4): System speed (20~99), Station speed (00~19)
6) Type (5): System speed (1000~9999), Station speed (000~099)
7) Type (6): System speed (100~999), Station speed (000~099)
8) Type (7): System speed (100~999), Station speed (00~09)
9) Type (8): System speed (10~99), Station speed (00~09)
10) Type (9): System speed (1~9), Station speed (0~0)
The notifications is displayed ‘Speed Numbering type is successfully changed. Please refresh this
page to reload Speed numbering data.” According to selecting Speed numbering type, the range
of System speed dial and Station speed dial is changed over the related PGM.