iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
230
This step is divided into 5 steps and you can make the desired function each step. The following
is the guide to make Name and add the function on each step:
Adding Function
1) To enter the function name, English, Numbering, Underscore (_) and Parentheses are
available. Function name has to be filled out.
2) To enter the step name, English, Numbering, and Special letters except Double
quotation marks are available.
3) The step name doesn’t need to be filled out, but the function has to be configured each
step.
4) To cancel or close this tab, click the close button (X) and pop up the blow;
1. Click the Add Function button.
2. On the below window, click the desired PGM in the left frame. First fill out the function
name and step name. To configure the step 1, click the Make table to check the desired
function and then click [Save] button.
Check All: check all functions
Save: Save the checked functions
Initialize: Initialize the checked functions
To Next Page
Loading...
