iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
110
3.3.6.4 Attendant Assignment – PGM 164
eMG80 is consist of 1 System attendant and 3 Main attendant. eMG800 is consist of 1 System
attendant and 4 Main attendant. The System Attendant has higher priority in call handling and
system management functions with access to PGM 0. As a default, the System Attendant is
assigned Station 100 for eMG80 and Station 1000 for eMG800. Main Attendants are not
assigned by default.
PROCEDURE:
ATTENDANT ASSIGNMENT
100 . . . . . .
1. Press the [PGM] button and dial 164.
ATTENDANT ASSIGNMENT
100 . . . . . .
2. Select the desired button:
Button 1: System Attendant
Button 2: Main Attendants
3. Use the dial-pad to enter desired station numbers for the
System and Main Attendants. Use the [SPEED] button to
erase an entry and the [VOL UP]/[VOL DOWN] button to
scroll through the Main Attendants.
4. Press the [Save] button to store the Attendant
3.3.6.5 Multi-cast RTP/RTCP Ports – PGM 165
Multi-cast is employed by the system to send BGM, MOH, paging and Push-To-Talk packets.
Employing a single multi-cast packet reduces the overall LAN traffic. In some cases, specifically
when multiple systems are connected to the same default router it may be advantageous to
define different ports for each system.
PROCEDURE:
MULTICAST RTP/RTCP
PRESS FLEX KEY (1-2)
1. Press the [PGM] button and dial 165.
MULTICAST RTP
PRESS FLEX_KEY (01-24)
Press Flex button 1 for RTP ports or Flex button 2 for RTCP
ports.
Press the desired Flex button; refer to Table 3.3.6.5-1. The
24 Flex buttons are used to assign ports for the first 24
RTP/RTCP functions. To assign port numbers for additional
RTP/RTCP functions, use the [VOL UP]/[VOL DOWN]
Use the dial-pad to enter desired data for the port, refer to
Table 3.3.6.5-1.
To Next Page
Loading...
