iPECS UCP - NTP Attributes

To Next Page

To Previous Page

iPECS eMG80 & eMG800 & UCP

Administration and Programming Manual Issue 1.6

140

3.3.6.23 NTP Attributes – PGM 195

The system can employ the Network Time Protocol (NTP) or ISDN clock to synchronize the

system time with the NTP time server or ISDN clock. The system requests the time from the NTP

server at 10-minute intervals and then determines the time differential. If the system time is more

2 seconds off the NTP time, the system time is adjusted to synchronize with the NTP server time.

PROCEDURE:

NTP ATTRIBUTES

PRESS FLEX KEY (1-1)

1. Press the [PGM] button and dial 195.

Press the Flex button for the desired NTP Attribute; refer to

Table 3.3.6.23-1.

Use the dial-pad to enter the desired data, refer to Table

3.3.6.23-1.

Press the [Save] button to store the data entry.

Table 3.3.6.23-1 NTP ATTRIBUTES

BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT

NETWORK TIME/DATE

(0-2): DISABLE(0)

Sets time synchronization for the

system as :

Disable

ISDN clock

NTP, NTP Attributes are set only

via the Web.

0: DISABLE

1: ISDN

2: NTP

DISABLE

iPECS UCP - NTP Attributes - PGM 195