iPECS UCP - CO Device Sequence Number - PGM 104; Emg CO Device Sequence Number; UCP CO Device Sequence Number

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
255
4.4.1.6 CO Device Sequence Number - PGM 104
Selecting CO Gateway/board Sequence Number will display the input entry page. Selecting the
blue colored text in the Table header will sort the table based on the selected column. Click [Save]
button after changing Value to apply.
Figure 4.4.1.6-1 eMG CO Device Sequence Number
Figure 4.4.1.6-1 UCP CO Device Sequence Number
The system configures the CO/IP Line numbers as discussed in section 2.3. In case of eMG,
each slot is assigned the starting CO/IP Line number based on the Order Numbering. With UCP,
each Module is assigned the starting CO/IP Line number based on the registration order. In
place of the default Order Numbering, the “Order” number assigned in this PGM can be used to
reorder the CO/IP numbering.