iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
323
4.4.4.3 VoIP Attributes - PGM 142
Selecting VoIP Attributes will display the Analog Attributes data input page. Enter a valid CO
range and click [Load] to enter the VoIP Attributes data. Use the check mark to indicate which
attributes to modify; data for checked attributes is stored by clicking [Save] button.
Enter CO Range
: eMG80: 1-74 / eMG800: 1-600 / UCP: 1-998
Figure 4.4.4.3-1 VoIP Attributes
Table 4.4.4.3-1 VoIP ATTRIBUTES
ATTRIBUTE DESCRIPTION RANGE DEFAULT
CO VoIP Mode
The VoIP channels can support iPECS,
H.323 or SIP protocols. This field defines the
protocol for the VoIP channel(s).
COMMON/
H323 only/
SIP only/
RTP-Packet-Relay only/
H323 & RTP-Packet-Relay/
COMMON
To Next Page
Loading...
