iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
490
Enter System Index Range
: eMG80: 1-360 / eMG800: 1-1200 / UCP: 1-2800
Figure 4.4.9.9-2 System Authorization Code Table
User can change COS for the system index range across the board and click the Range save
button to save.
Authorization codes are employed to control access to system resources and facilities. Walking
COS, CO/IP Group access, DISA calls and certain Call Forward types may require input of a valid
Authorization code. Codes up to 12 digits may be entered into the system database.
There are two types of Authorization codes, station and system. The Station entries are
associated with individual stations. The number of system Authorization codes varies based on
the configuration; the number of available codes is provided in Table 2.1-x. Each Authorization
code may be assigned a separate COS for Day, Night and Timed Ring mode operation.
The system will allow the station associated Authorization codes to be duplicated. However, the
iPECS will not allow duplicate or conflicting system level codes unless the ‘*’ and Authorization
table indexing is used to enter codes. Conflicting codes occur when a shorter code contains the
first digits of a longer code, i.e. 12 conflicts with 1234.
To Next Page
Loading...
