iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
286
4.4.2.9 PTT Group Access - PGM 119
Selecting PTT Group Access will display the PTT Group Access data input page. Enter a valid
Station range and click [Load] to enter the PTT Group Access data. Check the appropriate boxes
to allow or delete access to each PTT Group. Click [Save] button after changing Value to apply.
Figure 4.4.2.9-1 PTT Group Access
Each iPECS IP or LDP Phone is assigned to receive PTT announcements from any combination
of the ten (10) PTT groups. Note a station not assigned to any group will not receive PTT page
announcements including Internal All PTT group page. As a default, all stations except remote
stations are assigned to group 1.
To Next Page
Loading...
