iPECS UCP - Voice Mail Dialing Table

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
501
4.4.9.15 Voice Mail Dialing Table - PGM 234
Selecting Voice Mail Dialing Table will display the Voice Mail Dialing data entry page. Click [Save]
button after changing Value.
Figure 4.4.9.15-1 External Voice Mail Dialing Table
When an external Voice Mail system is used that connects to an SLT port, a digit sequence must
be defined for the system to signal various call characteristics to the Voice Mail system. The
external Voice Mail uses the sequences to determine appropriate announcements or further call
routing. The Table permits the definition of digits as either a prefix or suffix to other digits (station
number for mailbox identification). Sequences are defined for such call characteristics as Put Mail,
Get Mail, No Answer call, etc. as described in the following table.
Table 4.4.9.15-1 VOICE MAIL DIALING TABLE
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Voice Mail 1 (Put)
Code to send when the voice mail is to receive
call to record a message.
Put Mail.
When you enter the Digit, the following Digit
means as below:
P: Pause, D: DND, F: Flash
Prefix
Suffix
(Max. 12 Digits/
Include *, #, P, D, F)
Voice Mail 2 (Get)
Code to send when the voice mail is to playback
a recorded message.
Prefix
Suffix