iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
184
3.3.9.8 System Speed Zone Table – PGM 232
The System Speed Dial numbers can be grouped into zones. Only stations allowed can access
numbers within a zone, allowing System Speed Dials to be partitioned. Each zone can be
assigned to apply the appropriate Station and CO Line COS for the Speed Dial number prior to
dialing.
PROCEDURE:
SYSTEM SPEED ZONE PGM
ENTER BIN NO (01-10)
1. Press the [PGM] button and dial 232 and enter the bin
number (Ex.01).
SYSTEM SPEED ZONE 1
F1:ZN F 2:ST F3:TK F4:AK
Using the dial-pad, enter the zone number, 01~10.
Press Flex button 1~3 for the desired zone characteristic,
refer to Table 3.3.9.8-1.
Using the dial pad, enter the desired data as indicated in
Press the
button to store the data entry.
Table 3.3.9.8-1 SPEED ZONE (PGM 232)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
1
ENTER NEW ZONE RANGE
ZONE 1 : 2200- 4999
Speed Dial Bin range for zone. 2200-4999 eMG80:2200~4999,
eMG800:2200~9999
2
ENTER STA RANGE
ZONE 1 : 100 – 239
Station range for zone. 100-239 eMG80:100~239,
eMG800:1000~2199
3
SPEED ZONE 1 TOLL CHK
(1:ON/0:OFF) : ON
Assignment to apply toll
restriction.
0: OFF
1: ON
ON
4
SPEED ZONE 1 AUTH CHK
(1:ON/0:OFF) : ON
Speed Dial Authorization Check
for zone.
0: OFF
1: ON
ON
To Next Page
Loading...
