iPECS UCP - 2.46 Integrated Auto Attendant;Voice Mail; 2.46.1 Integrated AA;VM Overview

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
128
Table 3.3.6.17-1 SMDR ATTRIBUTES (PGM 177)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
3
RECORD TYPE
(1 : LD/ 0: ALL) : LD
The system can record all outgoing calls
or only long distance calls. Long
distance calls are identified by the LD
digit count and LD codes assigned in
Flex button 4 and 19, respectively.
0: ALL calls
1: LD
LD
4
LD CALL DIGIT COUNT
(07-15) : 07
Dialed numbers, which exceed the
assigned LD digit count, are considered
long distance calls for SMDR and COS
purposes.
07-15 07
5
PRINT INCOMING CALL
(1 : ON/ 0: OFF) : OFF
The system can output records for
incoming calls as well as outgoing calls.
If enabled, incoming calls are recorded
as well as outgoing calls.
0: OFF
1: ON
OFF
6
PRINT LOST CALL
(1 : ON/ 0: OFF) : ON
The system can provide lost call records,
records for unanswered incoming
(abandoned) calls.
0: OFF
1: ON
ON
7
RECORD IN DETAIL
(1 : ON/ 0: OFF) : ON
The system can output detailed call
records (ON) or summary information
(total number of calls, cost and cost for
each station).
0: OFF
1: ON
ON
8
HIDDEN DIALED DIGIT
( 0 – 9 ) : 0
For security purposes, digits dialed for
an outgoing call can be hidden and
replaced with “*”. This field defines the
number of digits to hide.
Button 24 below defines whether leading
or trailing digits are hidden. In addition,
the station must be assigned for SMDR
HIDE, PGM 113 button 5.
0~9 0
9
SMDR CURRENCY UNIT
…
The unit of currency used for call cost
can be identified with 3 alpha characters
for easy reference, refer to Table 2.1.2-
1.
-
10
COST PER PULSE
000000
When metering is provided by the PSTN,
the cost per metering pulse can be
assigned.
6 digits 000000
11
SMDR DECIMAL LOCATION
(0-5) : 0
This value determines the position of the
decimal in the Cost per Pulse, button 10,
starting from the right most digits.
0~5 0
12
SMDR START TIMER (1sec)
(000 – 250) : 000
To allow for call set-up times through the
PSTN, a “Valid call timer” can be set. A
call must be longer than the SMDR Start
Timer for a call record to be generated if
enabled under button 1 above.
000~250
seconds
000
13
SMTP IP ADDR (WEB)
0 . 0 . 0 . 0
SMTP Mail server IPv4 address to
receive the SMDR e-mail reports.
12-digits
14
USER MAIL ADDR (WEB)
…………………………
User e-mail address to receive the
SMDR e-mail reports, display only. To
change data, use Web Admin.