iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
16
2.4 General Admin and Menu Structure
The iPECS system can be configured to meet each customer's individual needs. System
configuration may be accomplished by entering the “Program mode” at an assigned Admin
Station or by pointing a Web Browser at the IP address of the MPB/UCP. Section 3 provides a
description of eMG system for data entry using the Admin Station. Section 4 discusses
configuration employing the Web browser. Note that some parameters are available through Web
Admin and not the Keyset Admin.
Configurable items are organized as “Data” groups with a common affect, i.e. station, system,
numbering plan, etc. Items are further grouped into “Programs” forming a multi-layered menu
structure as the following list. Each of the Program groups is assigned a three digit “Program”
(PGM) code used to access the group. The top level Data groups include:
- System ID & Numbering Plans
- Station Data
- Board Based Data
- CO Line Data
- System Data
- Station Group Data
- ISDN Line Data
- SIP Data
- Tables Data
- Networking Data
- H.323 Routing Table
- T-NET Data
- Zone Data
- Device Login
- UCS Data
- DECT Data
- Redundancy Data (for UCP600 & UCP2400)
- Hotel Data
- Green Mode for eMG
- Initialization
The default and range of values for each configurable parameter are provided in Section Web
admin programming. The index and charts are helpful references when entering data into the
system‘s database.
To Next Page
Loading...
