iPECS UCP - Pick up Group Assignment - PGM 192

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
162
Table 3.3.7.2-7 STATION GROUP ATTRIBUTES — UMS GROUP (PGM 191)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
12
UMS 410 HUNT TYPE
(1 : CIRC/ 0 : TERM): CIR
When a call is offered to the
group, the Hunt process can be
defined for Circular or Terminal
hunt group.
0: TERM
1: CIR
CIR
13
UMS 410 WRAP-UP TMR
(002 – 999) : 002
After terminating any call, the VM
port will be maintained in a busy
state for the duration of the
WRAP-UP Timer.
002~999
(seconds)
002
14
FORCED FWD DEST USAGE
(1:ON/0:OFF): OFF
Enables the system to redirect
group calls to the Forced
destination defined under button
15 below.
0: OFF
1: ON
OFF
15
UMS 410 FORCED DEST
S/H/V/SPD (DIAL 1-4)
When a call is delivered to the
group the system can redirect the
call to the Forced destination if
enabled under button 14 above.
1-4
(1:Station
2:Station group
3:VSF Announce
4:System speed)
-
16
GROUP NAME
……………………………….
A hunt group name can be
designated.
20 character ….
Table 3.3.7.2-8 STATION GROUP ATTRIBUTES — UCS SERVER GROUP (PGM 191)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
1
UCS SVR [411] ASSIGNED
UC Server 1 (01–16)
UCS Server number, this value
must be set to 1.
01-16 1
3.3.7.3 Pick Up Group Assignment – PGM 192
Under Pick-Up Group Assignments members are assigned to the Station Pick Up Group.
PROCEDURE:
PICKUP GRP ASSIGN
ENTER GRP NUM(00-49)
1. Press the [PGM] button and dial 192 and enter group
number (Ex. 00). (eMG80:00~49/ eMG800:0~199)
PICKUP GRP 00
…. …. ….
Use the dial pad to enter the desired Pickup Group.
The system will display the member of pickup group.
PICKUP GRP 00
…. …. ….
Note for group members, enter a station or station range.
For an individual station press the desired Flex button for the
position of the station in the group and dial the station
number. For a range, enter the first and last station number
in the range.
Press the [Save] button to store the data entry.