iPECS UCP - 3.4 Intercom Call Hold

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
272
4.4.2.3 Terminal Attributes - PGM 112
Selecting Terminal Attributes will display the Terminal Attributes data input page. Enter a valid
station range and click [Load] to enter Terminal Attributes data. Use the check boxes to indicate
which attributes to define; data for checked attributes is stored for the entire range of stations
by clicking [Save] Button after changing Value.
Figure 4.4.2.3-1 Terminal Attributes (PGM 112)
Terminal Attributes define features and functions available to the terminal itself. Generally, the
entry will turn the feature ON (enable) or OFF (disable). Refer to the following table for a
description of the features and the input required.
Table 4.4.2.3-1 Terminal Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Auto Speak
Selection
Enables [SPEAKER] activation when a CO/IP Line, DSS or
other feature button is pressed; there is no need to lift handset.
OFF
ON
ON
No-Touch Answer
Enables No-touch answer, which automatically connects
transferred calls to the station’s speakerphone after a short tone.
OFF
ON
OFF
ICM signaling
Mode
The user may select Hands-free (H), Privacy (P) or Tone Ring
(T) for the ICM Signaling mode.
H,
T,
P
T