iPECS UCP - 3.5 Intercom Caller Controlled Signaling

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
273
Table 4.4.2.3-1 Terminal Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Headset Ring
The user can select how to receive Incoming ring signals among
Speaker, Headset or Both.
Speaker/
Headset/
Both
Speaker
Speaker/Headset The user can select between Speaker and Headset for Call.
Speaker/
Headset/
Speaker
LCD Display LED
The LCD LED, upper left of LCD, may be used for Intercom Call
ring Indication or both Message Wait and ring Indication.
MWI/Ring,
Ring
MWI/Ring
Message Scroll
Speed
The user can adjust the scroll speed on message from 0 to 7. 0 ~7 3
Ear & Mic Headset
The user can use Ear Microphone Headset for Internal or
external calls if the phone has the Ear. Microphone headset
port.
OFF
ON
OFF
Enblock mode
When On, the user-dialed digits are stored at the iPECS IP or
LDP Phone until explicitly sent by the user. When sent, all dialed
digits are sent to the system in a block.
Enblock mode is only available to iPECS IP or LDP Phones with
3-Soft keys.
OFF
ON
OFF
Back Light Usage
The backlight of iPECS IP and LDP Phones is assigned to stay
off, light only when the station is busy, or light constantly. Please
check the phone if the feature is available before setting this
option.
Always Off/
Busy Only/
Always On
Busy Only
By Pass DTMF
When detected, DTMF from an SLT may be regenerated by
CO/IP Line interface circuitry, the SLT port can by-pass
detection so DTMF is not detected.
OFF
ON
OFF
Serial DSS Usage
Enables an LIP-8000/LIP-9000 station to have a Serial DSS
/BLF
Console attached.
Disable
Enable
Enable
Howler Tone Howler tone can be sent to a phone when left off-hook.
OFF
ON
ON
Flex Button Page
The iPECS LIP-9030 and 9040 have 8 and 12 Flexible buttons,
respectively. Additional Flex buttons are available using Flex
button pages. The phone can have up to 3 pages each with the
8 or 12 Flex buttons. Thus, an LIP-9030 can have 24 Flex
buttons and the LIP-9040 can have 36 Flex buttons.
The Navigation Up/Down button is used to scroll through the
Flex buttons pages assigned.
Use 1 Page
Use 2 Page
Use 3 Page
Use 3 Page
Align LCD
For the iPECS LIP-9010/20/30/40, character alignment for
messages to the phone can be right or left aligned by the
system, or alignment controlled by the phone (“Not Align”).
For the other phone, please check if the feature is available
before using this option.
Not Align
Align Left
Align Right
Not Align
Small Popup Use
If this option is set to ON, small popup is displayed on the LCD
of LIP-9030/9040.
If it is set to OFF, top bar is displayed instead of small popup.
OFF
ON
OFF
Large Popup
Timer
When Large popup timer is set to any value from 1 to 5 except
0, the display of large popup is disappeared after the timer
expired and then the large popup information is displayed at top
bar.
0~5
(Sec.)
0
Message Wait
Indication LED
User can program MWI (Message Wait Indication) LED
according to the following type:
MWI All,
VM MWI,
MWI ALL