iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
169
3.3.8.7 Prefix Dialing Table – PGM 206
With this table, three features can be supported.
1. Analog CO Call Charge with NPR metering.
2. SIP direct dialing with no wait inter-digit timer.
3. ISDN Prefix Call – ISDN en-block Dialing with Prefix Call Setup.
If first some digits (up to 8 digits) of outgoing dial number are matched with Prefix Code of each
table, this table can start work. By each CO-line (PGM 142 – F20), Table ID (0-6) can be set. This
table ID (PGM 142 – F20) is associated with PGM 206 – each table ID.
PROCEDURE:
PREFIX DIALING TABLES
ENTER BIN NO (001-500)
1. Press the [PGM] button and dial 206 and enter the bin
number (Ex.001).
PREFIX TABLE 001
PRESS FLEX KEY(01-10)
Use the dial-pad to enter the Table index number (bin).
Refer to Table 3.3.8.7-1
DISPLAY
2. Press the desired Flex button, refer to Table 3.3.8.7-1
Use the dial pad to enter desired data, refer to Table 3.3.8.7-
1...
Press the [Save] button to store the data entry.
Table 3.3.8.7-1 Prefix Dialing Table (PGM 206)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
1
001 PREFIX CODE
........
Enter the Prefix code. (Max 8
digits)
2
001 TABLE ID
(0 – 6) : 0
Enter Table ID (0-6). 0 means NOT
used.
0-6 0
3
001 MIN DIGIT
(00 – 30) : 00
Select the minimum dial digits (00-
30)
00-30 00
4
001 MAX DIGIT
(00 – 30) : 00
Select the minimum dial digits (00-
30)
00-30 00
5
001 NUM OF TYPE(0-6)
UNKNOWN(0)
Select Number of Type (0~6).
Unknown/International/National/
Network Spec/Subscriber/
Abbreviated /Reserved
0-6
(0:Unknown
1:International
2:National
3:Network Spec.
4:Subscriber
5:Abbreviated
6:Reserved)
UNKNOWN(0)
To Next Page
Loading...
